This belt fitting is a replica of a set excavated in tomb 2 in Balingen. Belts like this were worn by all Germanic tribes between the 5th and 6th century. Similar originals were found in a large diversity.
This set consists of one belt buckle, one piece that was attached to the place where the belt buckle was fastened, one belt end and one piece of fitting.
This set is handmade of brass. It is suitable for a belt with a width of 4 cm.
Length: 9.5 cm
Width: 5.5 cm;
Belt width: 4 cm;
Fastening: pin & ring;
Based on a historic original: Yes;
Transport weight (gram): 10 *
This item is produced in limited quantities only. This means that every piece is unique. Sizes & finish may vary lightly from piece to piece.
Packaged with 100% recycled material
When packaging this item, we exclusively use 100% recycled plastic and recycled paper/cardboard from FSC certified forests. We reuse a large part of the material directly without the intervention of a recycling process.
Recycle the material by separating your waste:
1. Cardboard: separate or reuse your paper.
2. Plastic cushions, clothing bags and plastic tape: separate or reuse your plastic. If possible, pierce the cushions with a volume reduction needle.
3. Paper packaging for jewelry and small items: these have a plastic inner layer. Remove these, then separate your paper and plastic.